Rear Wheel Alignment
REAR WHEEL ALIGNMENTADJUSTMENT
1. INSPECT TIRE
2. MEASURE VEHICLE HEIGHT
NOTICE: Before inspecting wheel alignment, adjust the vehicle height to the specified value.
3. INSPECT TOE-IN
If the toe-in is not within the specified range, inspect the suspension parts and replace them if necessary.
4. ADJUST TOE-IN
a. Loosen the toe adjust cam nut.
b. Turn the adjust cams by an equal amount to adjust toe-in.
HINT:
^ Try to adjust the toe-in to the center value.
^ The toe-in will change by the following specifications corresponding to each graduation of the cam.
Approximately 3.0 mm (0.12 inch)
c. Tighten the nut.
Torque: 50 Nm (510 kgf-cm, 37 ft. lbs.)
5. INSPECT CAMBER
Air suspension
Coil suspension
6. ADJUST CAMBER
a. Remove the rear suspension arm No.2.
b. According to the table, select the rear suspension arm No.2.
c. Install the rear suspension arm No.2.
d. Inspect toe-in.