Camshaft Bearing

Install the other bearing caps in the sequence shown with the arrow mark facing forward.

Install 4 new seal washers to the bearing cap bolts (1 to 4).
Apply a light coat of engine oil on the threads and under the heads of the bearing cap bolts (5 to 22).
Install the oil feed pipe with the 22 bearing cap bolts.
Uniformly tighten the 22 bearing cap bolts in several passes, in the sequence shown in the illustration.
Torque:
7.5 Nm (76 kgf-cm, 66 inch lbs.) for bolts 21 and 22
16 Nm (163 kgf-cm, 12 ft. lbs.) for other bolts

LH

Apply seal packing to the bearing cap as shown in the illustration.
Seal packing: Part No. 08826-00080 or equivalent
Seal width 1.5 to 2.0 mm (0.059 to 0.079 inch)

Install the front bearing cap.

HINT: Installing the front bearing cap will determine the thrust portion of the camshaft.

Install the other bearing caps in the sequence shown with the arrow mark facing forward.

Install 4 new seal washers to the bearing cap bolts (1 to 4).
Apply a light coat of engine oil on the threads and under the heads of the bearing cap bolts (5 to 22).

NOTICE: Do not apply engine oil under the heads of the bearing cap bolts (1 to 4).

Install the oil feed pipe and the 22 bearing cap bolts.
Uniformly tighten the 22 bearing cap bolts in several passes in the sequence shown in the illustration.
Torque:
7.5 Nm (76 kgf-cm, 66 inch lbs.) for bolts 21 and 22
m16 Nm (163 kgf-cm, 12 ft. lbs.) for other bolts