Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND ACCELERATION SENSOR: INSTALLATION

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND ACCELERATION SENSOR: INSTALLATION

1. INSTALL YAW RATE AND ACCELERATION SENSOR






(a) Connect the yaw rate and acceleration sensor connector.






(b) Install the yaw rate and acceleration sensor with the 2 bolts.
Torque: 15 Nm (153 kgf-cm, 11 ft-lbf)
NOTICE:
- Do not damage the yaw rate and acceleration sensor.
- Make sure that the yaw rate and acceleration sensor is installed securely.

(c) Install the 2 wire harness clamps.
2. INSTALL NO. 2 CONSOLE BOX DUCT Installation

3. INSTALL CONSOLE BOX Installation

4. INSTALL CONSOLE BOX REGISTER ASSEMBLY Installation

5. INSTALL REAR ASH RECEPTACLE ASSEMBLY Installation

6. INSTALL FRONT ASH RECEPTACLE ASSEMBLY Installation

7. INSTALL CONSOLE PANEL SUB-ASSEMBLY Installation

8. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH Installation

9. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH Installation

10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

12. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
HINT: Testing and Inspection.

13. CHECK FOR SENSOR SIGNAL
HINT: Test Mode Procedure.