Radiator: Service and Repair

Cooling Fan Motor and Shroud

Removal and Installation

On all engines

1. Drain the engine cooling system.





2. Remove the upper radiator sight shield.
3. Remove the air cleaner outlet tube.





4. Remove the six bolts and the two radiator upper support brackets.





5. NOTE: 3.9L shown; 3.0L similar.

Remove the upper radiator hose.





6. Remove the bolt and position the receiver drier aside.





7. Disconnect the dual flow coolant valve electrical connector and the A/C line from the fan shroud.





On 3.0L engines

8. Disconnect the Throttle Position (TP) sensor and the Idle Air Control (IAC) valve electrical connectors.





9. Remove the bracket.
1 Remove the bolts.
2 Remove the bracket.





On 3.9L engines

10. Remove the bolt and position the electric water pump aside.





On all engines

11. Disconnect the high pressure cooling fan bracket and line.





12. Using the appropriate special tool, install a new 0-ring on the power steering pressure hose fitting.





13. Separate the return hose from the fan shroud and position aside.





14. Remove the two bolts and position the fan shroud assembly.





15. Disconnect the return hose from the cooling fan and shroud and remove the cooling fan and shroud assembly.
16. Remove the A/C condenser.





17. Disconnect the lower radiator hose.





18. Remove the two bolts and position the multi-cooler assembly aside.





19. Remove the bolts and the condenser support brackets.





20. Remove the radiator.
21. To install, reverse the removal procedure.