Variable Induction Position Sensor: Testing and Inspection

VARIABLE TUMBLE SHUTTER VALVE POSITION SENSOR INSPECTION [MZR 1.5]

CAUTION:
- The variable tumble shutter valve position sensor cannot be removed as a single unit. When replacing the variable tumble shutter valve position sensor, replace it together with the variable tumble shutter valve actuator as a single unit.

1. Disconnect the negative battery cable.

2. Remove the fresh-air duct and air cleaner as a single unit. (See Service and Repair.)

3. Disconnect the variable tumble shutter valve actuator connector.

4. Verify terminal A value (variable tumble shutter valve position sensor output voltage) when battery voltage is applied to terminal B or D.










- If there is any malfunction, replace the variable tumble shutter valve actuator. (See Service and Repair.)