Variable Induction Position Sensor: Testing and Inspection

VARIABLE SWIRL SHUTTER VALVE SWITCH INSPECTION [L3 WITH TC]

NOTE:
- Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See Description and Operation.)

Voltage Inspection

1. Turn the ignition switch to the ON position (Engine off).

2. Verify that the PCM terminal 2AE voltage is as shown in the following table when the variable swirl shutter valve actuator rod is depressed and released by hand.











- If not as specified, perform the "Circuit Open/Short Inspection".

- If there is no open or short circuit, replace the intake manifold. (See Service and Repair.)

Variable swirl shutter valve switch output voltage





Circuit Open/Short Inspection









1. Disconnect the PCM connector. (See Service and Repair.)

2. Inspect the following harnesses for an open or short circuit. (Continuity check)

Open circuit

- If there is no continuity, there is an open circuit. Repair or replace the wiring harness.

- Variable swirl shutter valve switch terminal A and PCM terminal 2AE
- Variable swirl shutter valve switch terminal B and body ground.

Short circuit

- If there is continuity, there is a short circuit. Repair or replace the wiring harness.

- Variable swirl shutter valve switch terminal A and power supply
- Variable swirl shutter valve switch terminal A and body ground
- Variable swirl shutter valve switch terminal B and power supply