DTC P1260 [WL-C, WE-C (Australian, European (L.H.D. U.K.) specs.)]
id0102c4815600
|
DTC P1260 |
Theft detected Vehicle immobilizer |
|---|---|
|
DETECTION CONDITION
|
• Immobilizer system malfunction
|
|
POSSIBLE CAUSE
|
• Immobilizer system malfunction
• PCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAVE BEEN RECORDED
• Have FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS been recorded?
|
Yes
|
go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related service information availability.
• Is any related service information available?
|
Yes
|
Perform repair or diagnosis according to the available service information.
If the vehicle is not repaired, go to the next step.
|
|
No
|
go to the next step.
|
||
|
3
|
VERIFY STORED DTC IN IMMOBILIZER SYSTEM
• Turn the engine switch to the ON position (Engine off).
• Verify stored DTC in IMMOBILIZER SYSTEM.
• Are DTCs stored?
|
Yes
|
Go to appropriate DTC troubleshooting procedure.
|
|
No
|
go to the next step.
|
||
|
4
|
VERIFY THAT DTC P1260 TROUBLESHOOTING IS COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the M-MDS.
• Start the engine and warm-up to normal operating temperature.
• Retrieve the DTC using the M-MDS.
• Is the PENDING CODE same DTC present?
|
Yes
|
Replace PCM, then go to the next step.
|
|
No
|
go to the next step.
|
||
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform "After Repair Procedure".
• Is there any DTC present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
Troubleshooting completed.
|
||