TURBINE SHAFT SPEED (TSS) SENSOR INSPECTION [5R55S]

id0513c1252900

Caution

•  Water or foreign material entering the connector can cause poor connections or corrosion. Be sure that water or foreign material do not enter the connector when disconnecting it.

1.  Disconnect the negative battery cable.

2.  Remove the oxidation catalytic converter. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [WL-C, WE-C].)

3.  Remove the propeller shaft. (See PROPELLER SHAFT REMOVAL/INSTALLATION [5AT].)

4.  Remove the crossmember and transmission mount rubber. (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION [5R55S])

5.  Lower the transmission slightly.

6.  Disconnect the TSS sensor connector.

absggw00001186

Caution

•  Do not apply a shock in the TSS sensor.

•  Do not damage the terminals.

7.  Measure the resistance between the TSS sensor terminals.

absggw00001189

•  If there is any malfunction, replace the TSS sensor. (See TURBINE SHAFT SPEED (TSS) SENSOR REMOVAL/INSTALLATION [5R55S].)

8.  Connect the TSS sensor connector.

9.  Install the crossmember and transmission mount rubber. (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION [5R55S])

10.  Install the propeller shaft. (See PROPELLER SHAFT REMOVAL/INSTALLATION [5AT].)

11.  Install the oxidation catalytic converter. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [WL-C, WE-C].)

12.  Connect the negative battery cable.