INTERMEDIATE SHAFT SPEED (ISS) SENSOR REMOVAL/INSTALLATION [5R55S]

id0513c1253500

Caution

•  Water or foreign material entering the connector can cause poor connections or corrosion. Be sure that water or foreign material do not enter the connector when disconnecting it.

•  Do not damage the ISS sensor.

1.  Disconnect the negative battery cable.

2.  Remove the oxidation catalytic converter. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [WL-C, WE-C].)

3.  Remove the propeller shaft. (See PROPELLER SHAFT REMOVAL/INSTALLATION [5AT].)

4.  Remove the crossmember and transmission mount rubber. (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION [5R55S].)

5.  Lower the transmission slightly.

6.  Disconnect the ISS sensor connector.

7.  Remove the ISS sensor.

absggw00001187

Note

•  Inspect O-ring for damage. Install new O-ring if damaged. Lubricate the O-ring with petroleum jelly to prevent damage to the O-ring.

8.  Install the ISS sensor.

9.  Connect the ISS sensor connector.

10.  Install the crossmember and transmission mount rubber. (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION [5R55S].)

11.  Install the propeller shaft. (See PROPELLER SHAFT REMOVAL/INSTALLATION [5AT].)

12.  Install the oxidation catalytic converter (See EXHAUST SYSTEM REMOVAL/INSTALLATION [WL-C, WE-C].)

13.  Connect the negative battery cable.