BONNET REMOVAL/INSTALLATION
id091000802500
-
Warning
-
• Removing the bonnet without supporting it could cause the bonnet to fall and cause serious injury. Always perform the procedure with at least another person to prevent the bonnet from falling.
1. Disconnect the negative battery cable.
2. To remove the bonnet hinges, remove the following parts:
- (1) Radiator grille (See RADIATOR GRILLE REMOVAL/INSTALLATION.)
-
- (2) Front bumper (See FRONT BUMPER REMOVAL/INSTALLATION.)
-
- (3) Front combination lights (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION.)
-
- (4) Front side turn light (See FRONT SIDE TURN LIGHT REMOVAL/INSTALLATION.)
-
- (5) Front over fender (vehicles with front over fender) (See OVER FENDER REMOVAL/INSTALLATION.)
-
- (6) Front fender panel (See FRONT FENDER PANEL REMOVAL/INSTALLATION.)
-
3. Disconnect the windshield washer hose.
4. Remove in the order indicated in the table.
|
1
|
Bonnet insulator
|
|
2
|
Shroud seal weatherstrip
|
|
3
|
Bonnet
|
|
4
|
Bonnet hinge
|
|
5
|
Bonnet stay
|
5. Install in the reverse order of removal.
6. Adjust the bonnet. (See BONNET ADJUSTMENT.)
