DTC P0700 (Flash Code 185) Transmission Control System (MIL Request) (RZ4E-TC)

1. Engine control system check

Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) Diagnostic system check-engine controls".

2. TCM-related DTC check

1) Connect the scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Start the engine.

4) Observe the TCM-related DTC information on the scan tool. Is a TCM-related DTC set?

Yes

Go to the applicable DTC diagnosis.

No

=>Go to Current DTC check.

3. Current DTC check

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Start the engine.

4) Operate the vehicle under the conditions for running the DTC.

5) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to ECM replacement.

No

=>Go to Repair verification.

4. ECM replacement

Refer to "1.Engine 1Z.Engine Electrical Control(RZ4E-TC) ECM removal".

Refer to "1.Engine 1Z.Engine Electrical Control(RZ4E-TC) ECM installation".

Refer to "1.Engine 1Z.Engine Electrical Control(RZ4E-TC) ECM setting".

Procedure completion

=>Go to Repair verification.

5. Repair verification

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Start the engine.

4) Operate the vehicle under the conditions for running the DTC.

5) Observe the DTC information with a scan tool.