DTC P0016 (Flash Code 16) Crankshaft Position - Camshaft Position Correlation (RZ4E-TC)

Note

  • This DTC is set resulting from a mechanical system malfunction, such as an improperly installed timing gear or chain.
  • Engine reverse rotation may set this DTC.

1. Engine control system check

Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) Diagnostic system check-engine controls".

2. Prioritized DTC check

1) Connect the scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Start the engine. If the engine does not start, crank the engine for 10 seconds.

4) Observe the DTC information with a scan tool. Is DTC P0335, P0336, or P0340 set at the same time?

Yes

Go to the applicable DTC diagnosis.

Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) DTC P0335 (Flash Code 15) Crankshaft Position Sensor Circuit".

Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) DTC P0336 (Flash Code 15) Crankshaft Position Sensor Circuit Range/Performance".

Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) DTC P0340 (Flash Code 14) Camshaft Position Sensor Circuit".

No

=>Go to CKP sensor and CMP sensor inspection.

3. CKP sensor and CMP sensor inspection

1) Inspect the CKP sensor and CMP sensor for the following.

  • Damaged sensor
  • Loose or improperly installed sensor
  • Excessive clearance
  • Foreign material passing between the sensor and the flywheel or between the sensor and the sensor rotor.
  • Damaged flywheel or sensor rotor
  • Loose or improperly installed flywheel or sensor rotor

2) Inspect the engine mechanical timing for the following conditions.

  • Improperly installed timing gear or chain
  • Timing chain tensioner damage
  • Excessive play in timing chain
  • Timing chain that has jumped teeth

3) Repair or replace as necessary.

Procedure completion

=>Go to Repair verification.

4. Repair verification

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Start the engine. If the engine does not start, crank the engine for 10 seconds.

4) Operate the vehicle under the conditions for running the DTC.

5) Observe the DTC information with a scan tool.

Copyright Mazda Motor Corporation. All rights reserved.