DTC U2302 Immobilizer Anti-Scanning Mode (4JJ3 without DPD)

1. Engine control system check

Refer to "51.Engine Control 1A.Troubleshooting(4JJ3 without DPD) Diagnostic system check-engine controls".

2. Current DTC check

1) Connect the scan tool.

2) Turn OFF the ignition switch for 1 minute or more.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to Wireless access module system inspection.

No

=>Go to Immobilizer-related DTC check.

3. Wireless access module system inspection

1) Referring to the following, inspect the wireless access module system. Is the result normal?

Refer to "71.Security and Locks Control 10S.Troubleshooting(Wireless Access Module (Mid-version/Lo-version [Except Passive Entry and Start System])) Diagnostic system check-Wireless Access Module (Mid-version/Lo-version [Except Passive Entry and Start System])".

Refer to "71.Security and Locks Control 10S.Troubleshooting(Wireless Access Module (Hi-version [Passive Entry and Start System])) Diagnostic system check-Wireless Access Module (Hi-version[Passive Entry and Start System])".

Yes

Go to Intermittent conditions of engine.

Refer to "202.Engine 15D.Symptom(4JJ3 without DPD) intermittent conditions of engine".

No

Repair or replace as necessary.

=>Go to Repair verification.

4. Immobilizer-related DTC check

1) Observe the immobilizer-related DTC with a scan tool. Is an immobilizer-related DTC that starts with B set?

Yes

Go to the applicable DTC diagnosis.

No

=>Go to Immobilizer function check.

5. Immobilizer function check

1) Reprogram the immobilizer function into the ECM.

Refer to "1.Engine 1Z.Engine Electrical Control(4JJ3 without DPD) ECM setting".

Procedure completion

=>Go to Programming verification.

6. Programming verification

1) Connect the scan tool.

2) Turn OFF the ignition switch for 1 minute or more.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to ECM replacement.

No

=>Go to Repair verification.

7. ECM replacement

Refer to "1.Engine 1Z.Engine Electrical Control(4JJ3 without DPD) ECM removal".

Refer to "1.Engine 1Z.Engine Electrical Control(4JJ3 without DPD) ECM installation".

Refer to "1.Engine 1Z.Engine Electrical Control(4JJ3 without DPD) ECM setting".

Procedure completion

=>Go to Repair verification.

8. Repair verification

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch for 1 minute or more.

3) Start the engine.

4) Operate the vehicle under the conditions for running the DTC.

5) Observe the DTC information with a scan tool.