OIL CONTROL VALVE (OCV) INSPECTION [SKYACTIV-D 2.2]

id0110s5801400

Coil Resistance Inspection

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

3.  Remove the battery. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

4.  Remove the air inlet pipe and turbocharger air inlet hose as a single unit. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

5.  Disconnect the OCV connector.

6.  Measure the resistance between terminals A and B using an ohmmeter.

ac5wzw00009695

•  If not as specified, replace the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

7.  Install in the reverse order of removal.

Spool Valve Operation Inspection

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

3.  Remove the battery. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

4.  Remove the air inlet pipe and turbocharger air inlet hose as a single unit. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

5.  Remove the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

6.  Verify that the spool valve inside the OCV is at the position shown in the figure from the hydraulic passage.

ac5wzw00005021

•  If there is any malfunction, replace the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

7.  Verify that the battery is fully charged. (See BATTERY INSPECTION.)

•  If not as specified, recharge the battery. (See BATTERY RECHARGING.)

Note

•  When applying battery positive voltage between the OCV terminals, the connection can be either of the following:

―  Positive battery cable to terminal A, negative battery cable to terminal B

―  Positive battery cable to terminal B, negative battery cable to terminal A

ac5wzw00009695

8.  Verify that the spool valve operates and it moves to the position shown in the figure from the hydraulic passage when battery voltage is applied between OCV terminals A and B.

ac5wzw00005022

•  If there is any malfunction, replace the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

9.  Stop applying battery positive voltage and verify that the spool valve returns to its original position.

•  If there is any malfunction, replace the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

10.  Install the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

11.  Install in the reverse order of removal.