ENERGY-ABSORBING FORM REMOVAL/INSTALLATION

id091000888800

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Seal board upper (See SEAL BOARD UPPER REMOVAL/INSTALLATION.)

(2)  Front bumper (See FRONT BUMPER REMOVAL/INSTALLATION.)

(3)  Set plate (See SET PLATE REMOVAL/INSTALLATION.)

3.  Using a flathead screwdriver, press out the fastener pins in the direction of arrow (1) shown in the figure and remove them.

ac8wzw00000889

4.  Remove the energy-absorbing foam in the direction of arrow (2) shown in the figure.

5.  Install in the reverse order of removal.