VEHICLE SPEED CANNOT BE SET TO SPEED LIMIT [INTELLIGENT SPEED ASSISTANCE (ISA) (E)]

id1503e4030700

Note

•  Due to environmental effects, the system behavior may differ from the driver’s intentions even though the vehicle has no malfunction. To perform symptom troubleshooting, an understanding of the applicable system from the service highlights/technical guide is required. For details on the control conditions of the system, refer to the [INTELLIGENT SPEED ASSISTANCE (ISA)] operation in the service highlights/technical guide.

Outline

Description	•  The vehicle speed cannot be set to the speed limit displayed on the traffic sign using the cruise control switch.
Possible cause	•  Personalization feature not set •  Invalid SD card •  Cruise control switch malfunction •  Forward sensing camera (FSC) malfunction •  BCM malfunction

Diagnostic Procedure

Step	Inspection		Action
1	VERIFY ALL SYSTEM DTCs •  Perform the DTC inspection. (See DTC INSPECTION.) •  Are any DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting.
		No	Go to the next step.
2	VERIFY PERSONALIZATION FEATURES SETTING •  Verify the [Speed Limit Sign Threshold] condition using the personalization features. (Refer to the [PERSONALIZATION FEATURES] in the workshop manual) •  Has the [Speed Limit Sign Threshold] turned [+0 km/ h (+0 mph)]?	Yes	Complete the symptom troubleshooting. (Explain the system operation conditions to the customer.)
		No	Go to the next step.
3	VERIFY PERSONALIZATION FEATURES SETTING •  Verify the traffic sign speed limit sync condition using the personalization features. (Refer to the [PERSONALIZATION FEATURES] in the workshop manual) •  Was the speed limit sign threshold set to+0 km/h (+0 mph)?	Yes	Complete the symptom troubleshooting. (Explain the system operation conditions to the customer.)
		No	Go to the next step.
4	VERIFY IF SD CARD IS VALID •  Perform diagnostic assist function “Storage Diagnostic Test” MAP Areas. (Refer to the [DIAGNOSTIC ASSIST FUNCTION] in the workshop manual) •  Is the part normal?	Yes	Go to the next step.
		No	Explain to the customer that the SD card is not valid.
5	INSPECT CRUISE CONTROL SWITCH FOR MALFUNCTION •  Inspect the applicable part. (See CRUISE CONTROL SWITCH INSPECTION.) •  Is the part normal?	Yes	Go to the next step.
		No	Repair or replace the malfunctioning location and perform the repair completion verification. (See CRUISE CONTROL SWITCH REMOVAL/INSTALLATION.)
Repair completion verification	VERIFY THAT VEHICLE IS REPAIRED •  Install/connect the part removed/disconnected during the troubleshooting procedure. •  Has the malfunction symptom been eliminated?	Yes	Complete the symptom troubleshooting. (Explain contents of repair to customer)
		No	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [L.H.D. (E)].) (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [R.H.D.].) If the CAN communication is normal, perform the diagnosis from Step 1. •  If the malfunction is not resolved, replace the BCM. (See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION.)