CHARGE PORT-ELECTRICAL SUPPLY UNIT REMOVAL/INSTALLATION

id304000102200

1.  Disconnect the negative lead-acid battery terminal. (See NEGATIVE LEAD-ACID BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts.

(1)  Trunk mat (See TRUNK COVERING REMOVAL/INSTALLATION.)

(2)  Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)

(3)  Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

(4)  Trunk side upper trim (RH) (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)

3.  Partially peel back the trunk side trim (RH). (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

4.  Remove the connector shown in the figure.

a30zzw00004246

5.  Remove the nuts shown in the figure and remove the charge port-electrical supply unit

a30zzw00004519

6.  Install in the reverse order of removal.