NO. 4 ALL POWER WINDOWS ARE INOPERATIVE


4	All power windows are inoperative.
POSSIBLE CAUSE	• Power supply circuit or ground circuit malfunction - Burnt fuse (B+) - Open or short circuit in wiring harness between ignition switch (IG1) and power window main switch - Open or short circuit in wiring harness between power window main switch and power window motor - Open or short circuit in wiring harness between power window main switch and ground • Power window main switch malfunction (switch malfunction) • Power window motor malfunction


STEP	INSPECTION		ACTION
1	• Operate all power windows other than driver's side window using the power window main switch. • Does any power window operate?	Yes	Go to Step 4.
1		No	Go to the next step.
2	• Operate the driver's side power window using the power window main switch. • Does the power window operate?	Yes	Go to the next step.
2		No	Inspect for an open circuit in the wiring harness between the power window main switch and the body ground. Inspect the power window main switch connector connection. (damage/pulled-out pins, corrosion) Repair or replace if necessary
3	• Is the P.WIND 20 A fuse normal?	Yes	Replace with the appropriate standard fuse. If the fuse is melted, inspect the wiring harness for a short to ground. Repair or replace the wiring harness, then replace the fuse.
3	• Is the P.WIND 20 A fuse normal?	No	Replace the power window main switch. (See POWER WINDOW MAIN SWITCH INSPECTION [EXCEPT POWER RETRACTABLE HARDTOP].) (See POWER WINDOW MAIN SWITCH INSPECTION [POWER RETRACTABLE HARDTOP].)
4	• Operate the power window using the power window subswitch • Does the power window motor operate (rotate)? Caution • If the power window motor temperature is high, the motor may not rotate due to the motor internal bimetal function. Leave it untouched for about 3 min to cool it down, then reinspect.	Yes	Go to the next step.
4		No	Replace the power window motor. (See POWER WINDOW REGULATOR REMOVAL/INSTALLATION.)
5	• Remove the door glass from the carrier plate. • Make sure that the door glass moves smoothly using your hand. • Does the door glass move smoothly?	Yes	Replace the power window regulator guide.
5		No	Inspect for a bent regulator guide or other possible malfunction. If normal, replace the glass run channel
6	Note • Do not operate the power window main switch during the following inspection. • Inspect the continuity between power window main switch terminal (up-side I, D) and ground. • Is there continuity?	Yes	Go to the next step.
6		No	Replace the power window main switch. (See POWER WINDOW MAIN SWITCH INSPECTION [EXCEPT POWER RETRACTABLE HARDTOP].) (See POWER WINDOW MAIN SWITCH INSPECTION [POWER RETRACTABLE HARDTOP].)
7	Note • Do not operate the power window main switch during the following inspection. • Inspect the continuity between power window main switch terminal (down-side F, J) and ground. • Is there continuity?	Yes	Inspect for an open or short circuit in the wiring harness between the power window main switch and power window subswitch. Inspect the power window main switch and subswitch connector connections. (damage/pulled-out pins, corrosion) Repair or replace if necessary.
7		No	Replace the power window main switch. (See POWER WINDOW MAIN SWITCH INSPECTION [EXCEPT POWER RETRACTABLE HARDTOP].) (See POWER WINDOW MAIN SWITCH INSPECTION [POWER RETRACTABLE HARDTOP].)