HAZARD WARNING SWITCH INSPECTION
id091800803100
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [F35M-R].) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [B65M-R].)
- (2) Side wall (See SIDE WALL REMOVAL/INSTALLATION.)
- (3) Front console component (See FRONT CONSOLE COMPONENT REMOVAL/INSTALLATION.)
- (4) Glove compartment (Vehicles with center panel unit) (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)
- (5) Center panel unit (Vehicles with center panel unit) (See CENTER PANEL UNIT REMOVAL/INSTALLATION.)
- (6) Center panel (Vehicles without center panel unit) (See CENTER PANEL REMOVAL/INSTALLATION.)
- (7) Hazard warning switch (See HAZARD WARNING SWITCH REMOVAL/INSTALLATION.)
3. Verify that the continuity between the hazard warning switch terminals is as indicated in the table.
-
• If not as indicated in the table, replace the hazard warning switch.
