PASSENGER SEAT BELT REMINDER INSPECTION

id092200997600

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [F35M-R].) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [B65M-R].)

(2)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

(3)  Front console component (See FRONT CONSOLE COMPONENT REMOVAL/INSTALLATION.)

(4)  Glove compartment (vehicles with audio unit) (See GLOVE COMPARTMENT COVER REMOVAL/INSTALLATION.)

(5)  Center panel unit (vehicles without audio unit) (See CENTER PANEL UNIT REMOVAL/INSTALLATION.)

(6)  Center panel (vehicles without audio unit) (See CENTER PANEL REMOVAL/INSTALLATION.)

(7)  Hazard warning switch (See HAZARD WARNING SWITCH REMOVAL/INSTALLATION.)

(8)  Passenger seat belt reminder (See PASSENGER SEAT BELT REMINDER REMOVAL/INSTALLATION.)

3.  Apply battery positive voltage to passenger seat belt reminder terminal A, and connect terminal B to ground.

am2zzw00001906

4.  Verify that the LED illuminates.

•  If the LED does not illuminate, replace the passenger seat belt reminder.