ANTENNA FEEDER NO.1 INSPECTION
id092000812400
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [F35M-R].) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [B65M-R].)
- (2) Side wall (See SIDE WALL REMOVAL/INSTALLATION.)
- (3) Front console component (See FRONT CONSOLE COMPONENT REMOVAL/INSTALLATION.)
- (4) Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)
- (5) Center panel unit (See CENTER PANEL UNIT REMOVAL/INSTALLATION.)
- (6) A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)
3. Disconnect antenna feeder No.2.
4. Verify that the continuity between antenna feeder No.1 terminals is as indicated in the table.
-
• If not as indicated in the table, replace antenna feeder No.1.
