DTC U2101:00 [ABS]

DTC U2101:00 [ABS]

id0402a7879200

DTC

U2101:00

Signal error from instrument cluster

DETECTION CONDITION

• Correct data cannot be received from instrument cluster

POSSIBLE CAUSE

• Instrument cluster malfunction

Diagnostic procedure

STEP	INSPECTION		ACTION
1	RECORD THE VEHICLE INFORMATION DATA • Turn the ignition switch to the off. • Turn the ignition switch to the ON position, and maintain this condition for approx. 30 s.		Go to the next step.
2	VERIFY THAT THE SAME DTC IS NOT PRESENT • Clear the DTCs from the memory. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].) • Are the same DTCs present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, go to the next step.
2		No	Go to Step 5.
3	INSPECT FOR INSTRUMENT CLUSTER MALFUNCTION • Turn the ignition switch to the off. • Using the M-MDS, perform the DTC inspection for the instrument cluster. (See DTC INSPECTION [INSTRUMENT CLUSTER].) • Are any DTCs detected?	Yes	Go to applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER].) After repairing the instrument cluster, perform the “INSTRUMENT CLUSTER CONFIGURATION”, then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION.)
3		No	Go to the next step.
4	VERIFY THAT THE SAME DTC IS NOT PRESENT • Clear the DTCs from the memory. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].) • Are the same DTCs present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
4		No	Go to the next step.
5	VERIFY THAT NO OTHER DTCS ARE PRESENT • Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].)
5		No	DTC troubleshooting completed.