SECURITY LIGHT: 21, DTC: B10D8:00/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS AND START SYSTEM)]
id0902e3358000
|
DTC |
Security light flashing pattern |
21 |
Only one key has been programmed |
|
|---|---|---|---|---|
|
M-MDS display |
Keyless control module |
B10D8:00 |
||
|
PCM |
P1260:00 |
|||
|
POSSIBLE CAUSE
|
• Only one key has been programmed.
• Keyless control module malfunction
|
|||
Diagnostic Procedure
|
Step |
Inspection |
Action |
|
|---|---|---|---|
|
1
|
VERIFY NUMBER OF PROGRAMMED KEYS
• Using the M-MDS, perform the PID/data monitor inspection and verify the programmed keys.
• Are two or more keys programmed?
|
Yes
|
Go to the next step.
|
|
No
|
Program an additional key referring to the immobilizer system-related parts programming, then go to the next step.
|
||
|
2
|
PERFORM DTC INSPECTION AND VERIFY THAT MALFUNCTIONING PART IS KEYLESS CONTROL MODULE
• Using the programmed key, turn the ignition switch to the ON position.
• Clear DTCs using the M-MDS.
• Perform the immobilizer system DTC inspection using the M-MDS.
• Is the following DTC present?
|
Yes
|
Replace the keyless control module and program the immobilizer system-related parts.
Go to the next step.
|
|
No
|
Go to Step 4.
|
||
|
3
|
VERIFY TROUBLESHOOTING COMPLETED
• Clear DTCs using the M-MDS.
• Perform the immobilizer system DTC inspection using the M-MDS.
• Is the following DTC present?
|
Yes
|
Inspect the DTC P1260:00.
(See MZ-CD 1.6.)
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY THAT NO OTHER DTCs ARE PRESENT
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||