KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS AND START SYSTEM]


id0914004384b0

Note
•  If the keyless control module is replaced, always perform the following procedure.
―  Immobilizer system-related parts programming (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [ADVANCED KEYLESS AND START SYSTEM].)

1.  Disconnect the negative battery cable.

2.  Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

3.   Remove the glove compartment cover. (See GLOVE COMPARTMENT COVER REMOVAL/INSTALLATION.)

4.  Remove in the order indicated in the table.

am2zzw00000698

1
Nut
2
Connector
3
Keyless control module

5.  Install in the reverse order of removal.