DTC U0515:68 [INSTRUMENT CLUSTER]

id0902e8988000

DTC U0515:68

Signal error from keyless control module
Detection Condition
•  Instrument cluster receives the error signal from keyless control module.
Possible Causes
•  Keyless control module malfunction
•  Instrument cluster malfunction

Diagnostic Procedure

Step

Inspection

Action
1
PERFORM KEYLESS CONTROL MODULE DTC INSPECTION
•  Perform the keyless control module DTC inspection using the M-MDS.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [ADVANCED KEYLESS AND START SYSTEM].)
No
Go to the next step.
2
PERFORM DTC INSPECTION AND VERIFY THAT MALFUNCTIONING PART IS KEYLESS CONTROL MODULE
•  Clear the DTC using the M-MDS.
•  Turn the ignition switch to the ON position and wait for 20 s or more.
•  Perform the instrument cluster DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Replace the keyless control module, then go to the next step.
(See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS AND START SYSTEM].)
No
Go to Step 4.
3
VERIFY TROUBLESHOOTING COMPLETED
•  Clear the DTC using the M-MDS.
•  Turn the ignition switch to the ON position and wait for 20 s or more.
•  Perform the instrument cluster DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Replace the instrument cluster, then go to the next step.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
No
Go to the next step.
4
VERIFY THAT NO OTHER DTCs ARE PRESENT
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [INSTRUMENT CLUSTER].)
No
DTC troubleshooting completed.