DTC U0415:92 [INSTRUMENT CLUSTER]


id0902e8988400

Note
•  If the ignition switch is turned off after reprogramming the PCM and then turned to the ON position within 30 s, the PCM reprogramming cannot be completed correctly and DTC U0415:92 is stored.

DTC U0415:92

On request from ABS HU/CM or DSC HU/CM

Detection Condition
•  Instrument cluster receives the illumination command signal from ABS HU/CM or DSC HU/CM.
Possible Causes
•  ABS HU/CM or DSC HU/CM malfunction
•  Instrument cluster malfunction

Diagnostic Procedure

Step

Inspection

Action

1
PERFORM ABS HU/CM OR DSC HU/CM DTC INSPECTION
•  Perform the ABS HU/CM or DSC HU/CM DTC inspection using the M-MDS.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
No
Go to the next step.
2
PERFORM DTC INSPECTION AND VERIFY THAT MALFUNCTIONING PART IS ABS HU/CM OR DSC HU/CM
•  Clear the DTC using the M-MDS.
•  Turn the ignition switch to the ON position and wait for 20 s or more.
•  Increase the engine speed more than 500 rpm.
•  Perform the instrument cluster DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Replace the ABS HU/CM or DSC HU/CM, then go to the next step.
No
Go to Step 4.
3
VERIFY TROUBLESHOOTING COMPLETED
•  Clear the DTC using the M-MDS.
•  Turn the ignition switch to the ON position and wait for 20 s or more.
•  Increase the engine speed more than 500 rpm.
•  Perform the instrument cluster DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Replace the instrument cluster, then go to the next step.
No
Go to the next step.
4
VERIFY THAT NO OTHER DTCs ARE PRESENT
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
No
DTC troubleshooting completed.