ANTENNA FEEDER NO.2 INSPECTION
id092000812500
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Upper column cover (See COLUMN COVER REMOVAL/INSTALLATION.)
- (2) Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
- (3) Center panel (See CENTER PANEL REMOVAL/INSTALLATION.)
- (4) Audio unit (See AUDIO UNIT REMOVAL/INSTALLATION.)
- (5) Center cover (See CENTER COVER REMOVAL/INSTALLATION.)
- (6) Dashboard upper panel (See DASHBOARD UPPER PANEL REMOVAL/INSTALLATION.)
- (7) Front scuff plate (RH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
- (8) Front side trim (RH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
3. Disconnect the antenna feeder No.1.
4. Disconnect the antenna feeder No.5.
5. Verify that the continuity between antenna feeder No.2 terminals is as indicated in the table.
-
• If not as indicated in the table, replace antenna feeder No.2.
