REAR BUMPER REINFORCEMENT REMOVAL/INSTALLATION
id091000800900
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Trunk end trim (SeeTRUNK END TRIM REMOVAL/INSTALLATION.)
-
- (2) Trunk side trim (4SD) (SeeTRUNK SIDE TRIM REMOVAL/INSTALLATION.)
-
- (3) Trunk side trim (RH) (5HB) (SeeTRUNK SIDE TRIM REMOVAL/INSTALLATION.)
-
- (4) Service hole cover (LH) (5HB)
-
- (5) Rear combination lights (SeeREAR COMBINATION LIGHT REMOVAL/INSTALLATION.)
-
- (6) Rear bumper (SeeREAR BUMPER REMOVAL/INSTALLATION.)
-
3. Remove the nuts, then remove the rear bumper reinforcement.
4. Install in the reverse order of removal.
