CENTER ROOF ANTENNA REMOVAL/INSTALLATION
id092000801600
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Sunroof seaming welt (vehicles with sunroof)
- (2) Console (4SD) (See CONSOLE REMOVAL/INSTALLATION.)
- (3) A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)
- (4) Upper anchor of the front seat belt (See FRONT SEAT BELT REMOVAL/INSTALLATION.)
- (5) Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
- (6) Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)
- (7) B-pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)
- (8) B-pillar upper trim (See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)
- (9) Rear seat (See REAR SEAT REMOVAL/INSTALLATION.)
- (10) Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)
- (11) Trunk side upper trim (5HB) (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)
- (12) C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)
- (13) Map light (See MAP LIGHT REMOVAL/INSTALLATION.)
- (14) Interior light (See INTERIOR LIGHT REMOVAL/INSTALLATION.)
- (15) Sunvisor (See SUNVISOR REMOVAL/INSTALLATION.)
- (16) Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)
- (17) Headliner (See HEADLINER REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
Type A
|
1
|
Antenna rod
|
|
2
|
Antenna feeder
|
|
3
|
Nut
|
|
4
|
Center roof antenna
|
Type B
|
1
|
Antenna rod
|
|
2
|
Connector
|
|
3
|
Nut
|
|
4
|
Center roof antenna
|
|
5
|
Rubber
|
4. Install in the reverse order of removal.
5. After installation, verify that the rubber of the center roof antenna is installed to the roof panel with no space between them.
