THERMOSTAT REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5]
id011208801200
1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)
2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)
3. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)
4. Remove the aerodynamic under cover No.2 and splash shield as a single unit. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.)(See SPLASH SHIELD REMOVAL/INSTALLATION.)
5. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT [MZR 2.0, MZR 2.5].)
6. Remove the generator drive belt with the A/C drive belt still installed and set it out of the way. (MZR 2.0) (See DRIVE BELT REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)
7. Remove the drive belt. (MZR 2.5) (See DRIVE BELT REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)
8. Remove the drive belt auto tensioner. (MZR 2.0) (See ENGINE DISASSEMBLY/ASSEMBLY [MZR 2.0, MZR 2.5].)
9. Remove the drive belt idler pulley. (MZR 2.5) (See ENGINE DISASSEMBLY/ASSEMBLY [MZR 2.0, MZR 2.5].)
10. Remove in the order indicated in the table.
11. Install in the reverse order of removal.
12. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT [MZR 2.0, MZR 2.5].)
13. Inspect for engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION [MZR 2.0, MZR 2.5].)
am6xuw00002305
|
1
|
Water hose
|
2
|
Lower radiator hose
|
3
|
Thermostat component
|
4
|
Gasket
|