TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR INSPECTION [FS5A-EL]

id051721292100

Caution
•  Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

On-Vehicle Inspection

1.  Perform the following procedures.

(1)  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)
(2)  Disconnect the negative battery cable.
(3)  Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)
(4)  Disconnect the coupler component connector.
am8rrw00002340

2.  Measure the resistance between the coupler component terminals E and H.

am3uuw00002412

•  If there is any malfunction, replace the TFT sensor. (See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION [FS5A-EL].)

TFT sensor specification

ATF temperature (°C{°F})

Resistance (kilohm)
-20 {-4}
236—324
0 {32}
84.3—110
20 {68}
33.5—42.0
40 {104}
14.7—17.9
60 {140}
7.08—8.17
80 {176}
3.61—4.15
100 {212}
1.96—2.24
120 {248}
1.13—1.28
130 {266}
0.87—0.98


Off-Vehicle Inspection

1.  Place the TFT sensor and a thermometer in ATF as shown, and heat the ATF gradually.

ampjjw00005643

Warning
•  A hot ATF and beaker can cause severe burns. Do not touch them.

2.  Measure the resistance between the coupler component terminals E and H.

am3uuw00002412

•  If there is any malfunction, replace the TFT sensor. (See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION [FS5A-EL].)

TFT sensor specification

ATF temperature (°C{°F})

Resistance (kilohm)
-20 {-4}
236—324
0 {32}
84.3—110
20 {68}
33.5—42.0
40 {104}
14.7—17.9
60 {140}
7.08—8.17
80 {176}
3.61—4.15
100 {212}
1.96—2.24
120 {248}
1.13—1.28
130 {266}
0.87—0.98