UP SWITCH INSPECTION [FW6A-EL]

id0517h1600500


Continuity Inspection

Note
•  The up switch is built into the selector lever component.

1.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

2.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

3.  Remove the console. (See CONSOLE REMOVAL/INSTALLATION.)

4.  Disconnect the selector lever component connector.

am3zzw00012705

5.  Verify that the continuity between selector lever component terminals B and H.

am3uuw00008692

•  If not as verified, replace the selector lever component. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

Up switch specification

Test condition

Continuity
Selector lever is in the M position (+) side position.
Continuity
Selector lever is not in the M position (+) side position.
No continuity