DTC B1893 [INFORMATION DISPLAY/MULTI INFORMATION DISPLAY]

id0902k0935700

DESCRIPTION

Open circuit in GPS antenna circuit
DETECTION CONDITION
•  Multi information display detects open circuit in GPS antenna circuit for 5 s or more, while the ignition is ACC or ON.
POSSIBLE CAUSE
•  GPS antenna connector or terminals malfunction
•  Multi information display connector or terminals malfunction
•  GPS antenna feeder malfunction
•  GPS antenna malfunction
•  Multi information display malfunction

Diagnostic Procedure

STEP

INSPECTION

ACTION
1
INSPECT GPS ANTENNA CONNECTOR AND TERMINALS
•  Switch the ignition to off.
•  Disconnect the negative battery cable.
•  Disconnect the GPS antenna connector.
•  Inspect the connector and terminals (corrosion, damage, pin disconnection).
•  Is there any malfunction?
Yes
Repair or replace the connector or terminals, then go to Step 5.
No
Go to the next step.
2
INSPECT MULTI INFORMATION DISPLAY CONNECTOR AND TERMINALS
•  Disconnect the multi information display connector.
•  Inspect the connector and terminals (corrosion, damage, pin disconnection).
•  Is there any malfunction?
Yes
Repair or replace the connector or terminals, then go to Step 5.
No
Go to the next step.
3
INSPECT GPS ANTENNA FEEDER
•  Inspect the GPS antenna feeder.
•  Is there any malfunction?
Yes
Replace the GPS antenna feeder, then go to Step 5.
(See GPS ANTENNA FEEDER REMOVAL/INSTALLATION.)
No
Go to the next step.
4
PERFORM DTC INSPECTION AND VERIFY THAT MALFUNCTIONING PART IS GPS ANTENNA
•  Make sure to reconnect all disconnected connectors.
•  Reconnect the negative battery cable.
•  Clear the DTC from multi information display using the M-MDS.
•  Switch the ignition to ACC and wait for 5 s or more.
•  Perform the multi information display DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Replace the GPS antenna, then go to the next step.
(See GPS ANTENNA REMOVAL/INSTALLATION.)
No
Go to Step 6.
5
VERIFY TROUBLESHOOTING COMPLETED
•  Make sure to reconnect all disconnected connectors.
•  Reconnect the negative battery cable.
•  Clear the DTC from multi information display using the M-MDS.
•  Switch the ignition to ACC and wait for 5 s or more.
•  Perform the multi information display DTC inspection using the M-MDS.
•  Is the same DTC present?
Yes
Repeat the inspection from Step 1.
•  If the malfunction recurs, replace the multi information display.
Go to the next step.
No
Go to the next step.
6
VERIFY THAT NO OTHER DTCs ARE PRESENT
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [INFORMATION DISPLAY/MULTI INFORMATION DISPLAY].)
No
DTC troubleshooting completed.