DTC C0062:54 [DYNAMIC STABILITY CONTROL (DSC)]
id0402b2900900
|
DTC
|
C0062:54
|
DSC HU/CM system (unperformed initialization procedure)
|
|
|
DETECTION CONDITION
|
• DSC HU/CM detects that the initialization procedure for low-G (XY) sensor has not been performed.
|
||
|
POSSIBLE CAUSE
|
• Initialization procedure for the low-G (XY) sensor not performed
• SAS control module malfunction
• DSC HU/CM malfunction
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY INITIALIZATION PROCEDURE
• Was the low-G (XY) sensor initialization procedure performed?
|
Yes
|
Go to next step.
|
|
No
|
Perform the low-G (XY) sensor initialization procedure, then go to Step 3.
|
||
|
2
|
INSPECT FOR SAS CONTROL MODULE MALFUNCTION
• Switch the ignition to off.
• Using the M-MDS, perform the DTC inspection for the SAS control module.
(See DTC DISPLAY.)
• Are any DTCs detected?
|
Yes
|
Go to applicable DTC inspection.
(See DTC TABLE.)
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY THAT THE SAME DTC IS NOT PRESENT
• Clear the DTCs from the memory.
• Are the same DTCs present?
|
Yes
|
Repeat the inspection from Step 1.
If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY THAT NO OTHER DTCS ARE PRESENT
• Are any other DTCs output?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||