DOOR LOCK-LINK SWITCH INSPECTION

id091400430200

Font Door Lock-link Inspection

1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 80 mm {3.1 in}.

am6zzw00006752

2. Disconnect the negative battery cable.

3. Remove the following parts:

(1) Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION.)

(2) Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION.)

(3) Front door speaker (See FRONT DOOR SPEAKER REMOVAL/INSTALLATION.)

(4) Front door glass (See FRONT DOOR GLASS REMOVAL/INSTALLATION.)

(5) Front door module panel (See FRONT DOOR MODULE PANEL REMOVAL/INSTALLATION.)

(6) Front door latch and lock actuator (See FRONT DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION.)

4. If the door lock condition is to be inspected, pull the door lock-link switch cable, or press it in.

Note

• The door lock-link switch cable locks or unlocks only when the latch lever is locked.

am2zzw00000674

5. Verify that the continuity is as indicated in the table.

am6zzw00004515

• If not as indicated in the table, replace the front door latch and lock actuator.

am2zzw00000676

Rear Door Lock-link Inspection

1. Fully open the rear door glass.

2. Disconnect the negative battery cable.

3. Remove the following parts:

(1) Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION.)

(2) Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION.)

(3) Rear inner handle (See INNER HANDLE REMOVAL/INSTALLATION.)

(4) Rear door speaker (See REAR DOOR SPEAKER REMOVAL/INSTALLATION.)

(5) Rear door quarter glass (See REAR DOOR QUARTER GLASS REMOVAL/INSTALLATION.)

(6) Rear door glass (See REAR DOOR GLASS REMOVAL/INSTALLATION.)

(7) Rear door module panel (See REAR DOOR MODULE PANEL REMOVAL/INSTALLATION.)

(8) Rear door latch and lock actuator (See REAR DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION.)