REAR WIPER MOTOR INSPECTION

id091900801500

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  Rear wiper arm and blade (See REAR WIPER ARM AND BLADE REMOVAL/INSTALLATION.)

(2)  Liftgate upper trim (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION.)

(3)  Liftgate side trim (See LIFTGATE SIDE TRIM REMOVAL/INSTALLATION.)

(4)  Recess (See RECESS REMOVAL/INSTALLATION.)

(5)  Liftgate lower trim (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION.)

3.  Disconnect the rear wiper motor connector.

4.   Apply battery positive voltage to rear wiper motor connector terminal B, and connect terminals A and C to the ground.

5.  Verify that the rear wiper motor operates.

am3uuw00003329

•  If there is any malfunction, replace the rear wiper motor.

6.  Disconnect the ground to the terminal A while the rear wiper is operating.

7.  Verify that the rear wiper stops in the park position.

•  If there is any malfunction, replace the rear wiper motor.