PARKING SENSOR SWITCH INSPECTION


id092200775200

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  Front scuff plate (Driver side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
(2)  Front side trim (Driver side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
(3)  Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)
(4)  Decoration panel (Driver side) (See DECORATION PANEL REMOVAL/INSTALLATION.)
(5)  Bonnet release lever (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)
(6)  Lower panel (Driver side) (See LOWER PANEL REMOVAL/INSTALLATION.)
(7)  Parking sensor switch (See PARKING SENSOR SWITCH REMOVAL/INSTALLATION.)

3.  Verify that the continuity between the parking sensor switch terminals is as indicated in the table.

am6zzw00005055
am6zzw00003797

•  If not as indicated in the table, replace the parking sensor switch.

4.  Apply battery voltage to connect terminal H, and connect terminal J to ground.

5.  Verify that the LED illuminates.

•  If there is any malfunction, replace the parking sensor switch.

6.  Apply battery voltage to parking sensor switch terminal B, and connect terminal D to ground.

7.  Verify that the LED illuminates.

•  If there is any malfunction, replace the parking sensor switch.