WASHER MOTOR INSPECTION

id091900805100

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.) (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.) (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the set plate. (See SET PLATE REMOVAL/INSTALLATION.)

3.  Remove the fresh-air duct installation bolts. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 2.5T].) (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION)].) (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT CYLINDER DEACTIVATION)].) (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

4.  Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)

5.  Disconnect the washer motor connector from the washer motor.

am6zzw00009098

6.  Disconnect the windshield washer hose from the washer motor.

7.  Disconnect the rear washer hose from the washer motor (WGN).

Warning

•  Water sprayed on the battery and ground could cause electrocution. When performing the washer motor inspection, prepare a container to collect washer fluid and be careful not to spray washer fluid.

8.  After connecting washer motor terminal A to the positive battery terminal, and terminal B to ground, verify that washer fluid sprays from the front side of the washer motor.

ac5wzw00002204

am6zzw00017463

•  If there is any malfunction, replace the washer motor. (See WASHER MOTOR REMOVAL/INSTALLATION.)

9.  After connecting washer motor terminal B to the positive battery terminal, and washer motor terminal A to ground, verify that washer fluid sprays from the rear side of the washer motor (WGN).

ac5wzw00002205

am6zzw00017464

•  If there is any malfunction, replace the washer motor. (See WASHER MOTOR REMOVAL/INSTALLATION.)