|
DTC P0610
|
Control module vehicle options error
|
|---|---|
|
DETECTION CONDITION |
• PCM data configuration error
|
|
POSSIBLE CAUSE |
• Configuration procedure has not been completed
• PCM malfunction
|
Diagnostic procedure
|
STEP
|
INSPECTION
|
ACTION
|
|
|---|---|---|---|
|
1
|
PERFORM DTC CONFIRMATION PROCEDURE
• Perform the DTC CONFIRMATION PROCEDURE.
• Is the same DTC present?
|
Yes
|
Perform the PCM configuration procedure, then go to the next step.
(See PCM CONFIGURATION [LF, L3].)
|
|
No
|
Intermittent concern exists. Go to the INTERMITTENT CONCERN TROUBLESHOOTING procedure.
|
||
|
2
|
VERIFY TROUBLESHOOTING OF DTC P0610 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Turn the ignition switch to the ON position (Engine off).
• Clear the DTC from the PCM memory using the WDS or equivalent.
• Perform the KOEO/KOER self-test.
(See KOEO/KOER SELF-TEST [LF, L3].)
• Is the same DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the "After Repair Procedure".
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC troubleshooting.
(See DTC TABLE [LF, L3].)
|
|
No
|
Troubleshooting completed.
|
||