BRAKE LIGHT UNIT REMOVAL/INSTALLATION

id091800400000

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Perform the following procedure:

4SD

1.  Remove the following parts:

1.  Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION.)

2.  Rear side seat back (See REAR SIDE SEAT BACK REMOVAL/INSTALLATION.)

3.  Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

4.  C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

5.  High-mount brake light (See HIGH-MOUNT BRAKE LIGHT REMOVAL/INSTALLATION.)

2.  Fold the rear seat back.

3.  Remove the rear package trim. (See REAR PACKAGE TRIM REMOVAL/INSTALLATION.)

WGN

1.  Remove the following parts:

1.  Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)

2.  Trunk side pocket (LH) (See TRUNK SIDE POCKET REMOVAL/INSTALLATION.)

3.  Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

2.  Partially peel back the trunk side upper trim (LH) and trunk side trim (LH). (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.) (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

3.  Disconnect the connector.

am6zzw00009209

4.  Remove the bolt.

5.  Pull out the hook in the direction of the arrow (1) shown in the figure.

am6zzw00011253

6.  Remove the brake light unit.

7.  Install in the reverse order of removal.