SECONDARY CONTROL VALVE BODY REMOVAL [FS5A-EL]

id051721807500

On‐Vehicle Removal

Warning

•  Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eyeglasses whenever using compressed air.

Caution

•  If any old sealant gets into the transaxle during installation of the oil pan, trouble may occur in the transaxle case and oil pan. Clean with cleaning fluids.

1.  Disconnect the negative battery cable.

2.  Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.

3.  Remove the battery and battery tray. (SeeBATTERY REMOVAL/INSTALLATION [L8, LF, L5].)

4.  Remove the aerodynamic under cover NO.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.)

5.  Drain the ATF into a separate suitable container. (SeeAUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FS5A-EL].)

6.  Remove the EPS control module. (SeeEPS CONTROL MODULE REMOVAL/INSTALLATION.)

7.  Remove the oil cover.

8.  Disconnect the solenoid connectors.

am6zzw00002904

9.  Remove the secondary control valve body installation bolts as shown, then remove the secondary control valve body component and ground.

am6zzw00002905

10.  Remove the tubular pin and O-ring.

am6zzw00002906