DTC U0515:92 [INSTRUMENT CLUSTER]

DTC U0515:92 [INSTRUMENT CLUSTER]

id0902e8989300

DTC U0515:92

On request from keyless control module

Detection Condition

Illumination command signal from Keyless control module continues for 20 s or more

Possible Causes

Keyless control module malfunction

Diagnostic Procedure

Step	Inspection		Action
1	INSPECT FOR KEYLESS CONTROL MODULE MALFUNCTION • Switch the ignition to off. • Connect the M-MDS to the DLC-2. • Perform the keyless control module DTC inspection using the M-MDS. (See DTC INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].) • Is the DTC displayed again?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].)
1		No	Go to the next step.
2	VERIFY THAT NO OTHER DTCs ARE RECORDED • Clear DTCs using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER].) • Perform the instrument cluster DTC inspection using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER].) • Is DTC U0515:92 displayed?	Yes	Replace the keyless control module. (See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].)
2		No	DTC troubleshooting completed.