AFS OFF LIGHT FLASHING PATTERN 1, DTC U0483:68 [AFS (ADAPTIVE FRONT LIGHTING SYSTEM)]
id0902g9936200
Description |
• AFS control module CAN communication signal error
|
---|---|
Detection condition
|
• AFS control module detects CAN communication error continuously for 5 s while ignition is switched ON
|
Possible cause
|
• Steering angle sensor initialization not completed
• Communication error between AFS control module and PCM (vehicle speed signal)
• Communication error between AFS control module and BCM (steering angle signal)
• AFS control module internal malfunction
|
Diagnostic Procedure
Step |
Inspection |
Action |
|
---|---|---|---|
1
|
VERIFY IF STEERING ANGLE SENSOR INITIALIZATION NOT COMPLETED
• Perform steering angle sensor initialization.
• Inspect for AFS DTCs.
• Does the AFS OFF light flash in flashing pattern 1?
|
Yes
|
Go to the next step.
|
No
|
Go to Step 4.
|
||
2
|
VERIFY IF MALFUNCTION CAUSED BY PCM, BCM MALFUNCTION
• Perform the PCM and BCM DTC inspection using the M-MDS.
(See FOREWORD [MZR-CD 2.2].)
(See DTC INSPECTION [BCM].)
• Are any DTCs output?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [L8, LF, L5].)
(See DTC TABLE [MZR-CD 2.2].)
(See DTC TABLE [BCM].)
|
No
|
Go to the next step.
|
||
3
|
VERIFY IF MALFUNCTION CAUSED BY AFS CONTROL MODULE MALFUNCTION
• Inspect for AFS DTCs.
• Does the AFS OFF light flash in flashing pattern 1?
|
Yes
|
Replace the AFS control module, then go to the next step.
|
No
|
Go to the next step.
|
||
4
|
VERIFY OTHER DTC DISPLAYED
• Verify if other DTCs are displayed.
• Are any other DTCs displayed?
|
Yes
|
Perform troubleshooting according to the corresponding DTC inspection.
|
No
|
DTC troubleshooting completed.
|