DTC TABLE [BCM]

id0902f5347100

DTC table

DTC No.

Description

Detection condition

Page
B1C45:12
Autostop switch circuit malfunction
Short circuit to power supply in wiring harness between windshield wiper motor and BCM
(See DTC B1C45:12 [BCM].)
B1D35:11
Hazard warning switch circuit malfunction
Short to ground detected in hazard warning switch circuit with the hazard warning switch off
(See DTC B1D35:11 [BCM].)
B1D36:11
Turn switch circuit malfunction
Short to ground detected in turn switch LH or RH circuit with the turn switch off
(See DTC B1D36:11 [BCM].)
B10A5:49
Theft-deterrent siren internal malfunction
Theft-deterrent siren internal malfunction
(See DTC B10A5:49 [BCM].)
B10A5:86
Signal error from theft-deterrent siren
Signal error from theft-deterrent siren
(See DTC B10A5:86 [BCM].)
B10A5:87
Communication error between theft-deterrent siren and BCM
Communication error between theft-deterrent siren and BCM
(See DTC B10A5:87 [BCM].)
B10D0:11
Trunk lid opener switch (4SD) /liftgate opener switch (5HB, WGN) circuit malfunction
Short to ground detected in trunk lid opener switch (4SD) /liftgate opener switch (5HB, WGN) circuit with the ignition switch on
(See DTC B10D0:11 [BCM].)
B1007:12
Headlight high beam circuit malfunction
Short to power supply detected in headlight high beam circuit with the light switch off
(See DTC B1007:12 [BCM].)
B1008:11
Windshield wiper switch circuit malfunction
Short to ground detected in windshield wiper switch circuit with the windshield wiper switch off
(See DTC B1008:11 [BCM].)
B1047:11
Rear fog light switch circuit malfunction
Short to ground detected in rear fog light switch circuit with the rear fog light switch off
(See DTC B1047:11 [BCM].)
B1048:11
Brake fluid level sensor circuit malfunction
Short to ground in brake fluid level sensor circuit with the brake fluid amount on the upper side of the minimum
(See DTC B1048:11 [BCM].)
B1051:11
Windshield washer switch circuit malfunction
Short to ground detected in windshield washer switch circuit with the windshield washer switch off
(See DTC B1051:11 [BCM].)
B1052:11
Rear washer switch circuit malfunction
Short to ground detected in rear washer switch circuit with the rear washer switch off
(See DTC B1052:11 [BCM].)
B1079:13
Bonnet latch switch circuit malfunction
Open circuit detected in bonnet latch switch circuit with the bonnet closed (bonnet latch switch on)
(See DTC B1079:13 [BCM].)
B109F:49
Intruder sensor internal malfunction
Intruder sensor internal malfunction
(See DTC B109F:49 [BCM].)
B109F:86
Signal error from intruder sensor
Signal error from intruder sensor
(See DTC B109F:86 [BCM].)
B109F:87
Communication error between intruder sensor and BCM
Communication error between intruder sensor and BCM
(See DTC B109F:87 [BCM].)
B11C0:13
Driver’s side rear door latch switch circuit malfunction
Open circuit detected in driver’s side rear door latch switch with the rear door (driver’s side) closed (driver’s side rear door latch switch on)
(See DTC B11C0:13 [BCM].)
B11C1:13
Passenger’s side rear door latch switch circuit malfunction
Open circuit detected in passenger’s side rear door latch switch circuit with the rear door (passenger’s side) closed (passenger's side rear door latch switch on)
(See DTC B11C1:13 [BCM].)
B11DA:11
Front door key cylinder switch (driver’s side) circuit malfunction
Short to ground detected in front door key cylinder switch (driver’s side) circuit with the front door key cylinder switch (driver’s side) off
(See DTC B11DA:11 [BCM].)
B11DC:11
Rear wiper switch circuit malfunction
Short to ground in rear wiper switch circuit with the rear wiper switch off
(See DTC B11DC:11 [BCM].)
B1172:11
Front door lock-link switch (driver’s side) circuit malfunction
Short to ground in front door lock-link switch (driver’s side) lock-side circuit with the front door lock-link switch (driver’s side) unlocked
(See DTC B1172:11 [BCM].)
B1172:13
Front door lock-link switch (driver’s side) circuit malfunction
Open circuit detected in front door lock-link switch (driver’s side) unlock-side circuit with the front door lock-link switch (driver’s side) unlocked
(See DTC B1172:13 [BCM].)
B1174:13
Door lock-link switch circuit malfunction
Open circuit detected in door lock-link switch unlock-side circuit with the door lock-link switch unlocked
(See DTC B1174:13 [BCM].)
B1175:13
Front door latch switch (driver’s side) circuit malfunction
Open circuit detected in front door latch switch (driver’s side) circuit with the front driver’s door closed (front door latch switch {driver’s side} on)
(See DTC B1175:13 [BCM].)
B1176:13
Front door latch switch (passenger’s side) circuit malfunction
Open circuit detected in front door latch switch (passenger’s side) circuit with the front passenger’s door closed (front door latch switch {passenger’s side} on)
(See DTC B1176:13 [BCM].)
B1178:11
Trunk lid switch (4SD) /liftgate latch switch (5HB) /cargo compartment light switch (WGN) circuit malfunction
Short to ground detected in trunk lid latch switch (4SD)/liftgate latch switch (5HB) /cargo compartment light switch (WGN) circuit with the trunk (4SD)/liftgate (5HB, WGN) closed (switch off)
(See DTC B1178:11 [BCM].)
C0051:04
•  Sensor Z-signal input circuit malfunction
•  Steering angle overflow
•  Z-signal does not change
•  Detected steering angle exceeds the specified value
(See DTC C0051:04 [BCM].)
C0051:2F
Steering angle signal error
Errors detected in a combination of signals from each sensor (A, B, C, D)
(See DTC C0051:2F/C0052:11/C0052:13/C0053:11/C0053:13/C0054:11/C0054:13/C0055:11/C0055:13 [BCM].)
C0052:11
Sensor A signal input circuit error
Voltage lower than the specification is detected for 0.1 s with the steering angle sensor connected
C0052:13
Voltage higher than the specification is detected for 0.1 s with the steering angle sensor connected
C0053:11
Sensor B signal input circuit error
Voltage lower than the specification is detected for 0.1 s with the steering angle sensor connected
C0053:13
Voltage higher than the specification is detected for 0.1 s with the steering angle sensor connected
C0054:11
Sensor C signal input circuit error
Voltage lower than the specification is detected for 0.1 s with the steering angle sensor connected
C0054:13
Voltage higher than the specification is detected for 0.1 s with the steering angle sensor connected
C0055:11
Sensor D signal input circuit error
Voltage lower than the specification is detected for 0.1 s with the steering angle sensor connected
C0055:13
Voltage higher than the specification is detected for 0.1 s with the steering angle sensor connected
C1137:12
Transaxle range switch (ATX) /back-up light switch (MTX) circuit malfunction
Short to power supply in transaxle range switch (ATX) /back-up light switch (MTX) circuit with the shift lever in R position (transaxle range switch {ATX} /back-up light switch {MTX} on)
(See DTC C1137:12 [BCM].)
P1536:13
Parking brake switch circuit malfunction
Open circuit detected in parking brake switch circuit with the parking brake lever applied (parking brake switch on)
(See DTC P1536:13 [BCM].)
U0001:88
Unit communication error (HS–CAN)
CAN system error with BCM
(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (L8, LF, L5, MZR-CD (RF Turbo))].)
(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (MZR-CD 2.2)].)
U0100:00
PCM communication error
Communication error between PCM and BCM
U0101:00
TCM communication error
Communication error between TCM and BCM
U0151:00
SAS control module communication error
Communication error between SAS control module and BCM
U0214:00
Keyless control module communication error
Communication error between keyless control module and BCM
U0300:00
BCM configuration setting invalid
Caution
•  Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
•  BCM configuration setting not done correctly
(See DTC U0300:00 [BCM].)
U0401:68
Correct data cannot be received from PCM
Correct data cannot be received from PCM
(See DTC U0401:68 [BCM].)
U0402:68
Correct data cannot be received from TCM
Correct data cannot be received from TCM
(See DTC U0402:68 [BCM].)
U2100:00
BCM configuration not set
Caution
•  Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
•  BCM configuration setting not done correctly
(See DTC U2100:00 [BCM].)
U3000:04
BCM internal malfunction
BCM internal malfunction
(See DTC U3000:04 [BCM].)
U3003:16
BCM power supply voltage malfunction
BCM power supply voltage low (less than 10 V)
(See DTC U3003:16/U3003:17 [BCM].)
U3003:17
BCM power supply voltage increases (16 V or more)