Ignition Control Module: Service and Repair

Ignition Module Assembly:

Ignition Module Mounting:

REMOVAL
1. Turn the ignition key OFF.
2. Remove the three module sub-bracket attaching nuts.
3. Gently pull the sub-bracket and module assembly straight up and disconnect the module electrical harness.
4. Remove the two module attaching screws from the sub-bracket. Remove the ignition module from the sub-bracket.

INSTALLATION
1. Position the module on the sub-bracket.
2. Install the two module attaching screws and torque to 24-35 lb. in. (3-4 N-m).
3. Connect the electrical harness to the ignition module.
4. Position the module and sub-bracket on the module bracket assembly.
5. Install the three attaching nuts and tighten the nuts to specified torque.