DTC 25/35 - Security L.E.D. (With UA6 Only)

Circuit Description





The BCM provides an output on circuit 1376 to the Security L.E.D. (if installed), (see Attachment 14).

DTC Will Set When

Battery is applied to the BCM through connector C2 and the BCM "sees" an L.E.D. circuit through connector C3 terminal "C16". The presence of the L.E.D. connected through connector C3 at the time of battery connection (connection C2) is required for proper UTD operation. If the L.E.D. is present on the vehicle and DTCs 25/35 are not indicated, verify continuity of circuit 1376 and circuit 650. Check for proper connections at BCM connector C3 and at the L.E.D., then disconnect and reconnect connector C2 to the BCM.

Notice:
Do not use battery or test light to test Theft Deterrent Security L.E.D. Failure to follow proper test procedures will damage the L.E.D.

Important:
Ignore DTCs 25/35 on vehicles not equipped with (UA6) Universal Theft Deterrent System.