Changing the Feature Customization Modes

Perform the following procedure to change the feature customization modes:
1. Turn off the IP dimmer switch.
2. Thin the ignition switch to the OFF position.
3. Remove the MALL PGM Fuse.
4. Thin the ignition switch to the ACC position.
^ The Body Control Module (BCM) flashes the fasten belts indicator and flashes the fasten belt indicator and sounds the chime four times, identifying that the BCM type 4 is installed on the vehicle.
^ Now the BCM has entered the feature customization mode.
5. To change the theft deterrent/shock sensor mode, turn the headlamp switch from OFF to PARK, back to OFF.
^ The BCM flashes the fasten belts indicator and sounds the chime a number of times equivalent to the theft deterrent/shock sensor mode. A transition past mode 4 repeats the sequence starting with mode 1.
6. To change the theft deterrent arm/disarm modes mode, insert key in door lock cylinder; rotate key from the center to unlock position, back to center position. The BCM flashes the fasten belts indicator and sounds the chime a number of times equivalent to the theft deterrent arm/disarm mode. A transition past mode 3 repeats the sequence starting with mode 1.

To exit and save the current feature customization modes:
1. Turn the ignition switch to the OFF position.
2. Reinstall the MALL PGM Fuse.

If unable to change locking modes, refer to Table 1: Cannot Change Feature Customization Modes for the diagnosis and repair. Table 1 Cannot Change Feature Customization Modes