General Description

The remote keyless entry system performs the following functions:
^ Locks and unlocks the vehicle doors
^ Opens the rear compartment lid The remote keyless entry system has an alarm feature. The alarm performs the following functions:
^ Sounds the horn
^ Illuminates the interior lamps
^ Flashes the headlamps

The keyless entry system operates on a radio frequency subject to the Federal Communications Commission (FCC) Rules.

The keyless entry device complies with Part 15 of the FCC Rules. Operation is subject to the following 2 conditions:
^ The keyless entry device may not cause harmful interference.
^ The keyless entry device must accept any interference received, including interference that may cause undesired operation.

Remote Control Door Lock Transmitter
The transmitter is a hand-held device that is powered by a 3.0 volt lithium battery. Data transmits on a RF carrier frequency at 315 MHz.

Up to 4 transmitter buttons control the functions of the system:
^ LOCK (upper left)
^ UNLOCK (upper right)
^ Rear Compartment (lower right)
^ Alarm (lower left), if equipped with a theft deterrent system

The operating range of the transmitter is 1-9 m (3-29 ft). At times, you may notice a decrease in range. This is normal for any remote lock control system. If the transmitter does not work or if you have to stand closer to the vehicle for the transmitter to work, perform the following steps:
^ Determine if battery replacement is needed.
^ Test the distance. You may be too far from the vehicle. You may need to stand closer during rainy or snowy weather.
^ Inspect the location. Other vehicles or objects may be blocking the signal. Take a few steps to the left or to the right or hold the transmitter higher.

Remote Control Door Lock Receiver
The remote control door lock receiver is in the instrument panel. The vehicle battery powers the remote control door lock receiver through the wiring harness of the instrument panel. The remote control door lock receiver performs the following functions:
1. Determines which command is sent by the remote control door lock transmitter.
2. Sends the appropriate signal to the body control module (BCM) for the command to be carried out. The remote control door lock receiver is independent of the BCM.

The remote control door lock receiver directly carries out the rear compartment lid release function