Knock Sensor: Service and Repair

CAUTION: Hot engine coolant may cause severe burns. Although the cooling system has been drained, coolant still remains in the engine water Jacket. This coolant will drain with the removal of the knock sensor:

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Raise the vehicle.
3. Remove the splash shield.
4. Drain the cooling system. Refer to Cooling System.

Knock Sensor:

5. Remove the knock sensor heat shield mounting bolt located under the freeze plug (or block heater if equipped).
6. Disconnect the knock sensor wiring harness connector from the knock sensor.

Knock Sensor:

7. Remove the knock sensor from the engine block.



INSTALLATION PROCEDURE

IMPORTANT: Do Not apply thread sealant to sensor threads. The sensor is coated at factory and applying additional sealant will affect the sensor's ability to detect detonation.

1. Install the knock sensor into the engine block.
Tighten
^ Knock sensor to 19 Nm (14 lb. ft.).
2. Install the knock sensor heat shield mounting bolt located under the freeze plug (or block heater if equipped).
3. Connect the knock sensor wiring harness connector to the knock sensor.
4. Install the splash shield.
5. Lower the vehicle.
6. Fill the cooling system. Refer to Cooling System.
7. Connect the negative battery cable.