Ignition Control Module: Service and Repair

REMOVE OR DISCONNECT
1. All electrical connectors at ignition control module.
2. Note the position of spark plug wires for installation.
3. Spark plug wires from ignition coils.
4. Ignition control module assembly from engine.
5. Screws securing coil assemblies to ignition control module.
6. Coils from ignition control module.

INSTALL OR CONNECT
1. Coils to the ignition control module.
2. Screws and tighten to 4-5 Nm (40 lb in).
3. Fasteners securing assembly to the engine and tighten to 8 Nm (70 lb in).
4. Spark plug wires as noted during the removal.
5. Electrical connectors to the ignition control module.